• LEAK STOP SEALANT
  • PRODUCT CODE:F159G
  • SPECIFICATION:500ML X 12PCS
  • VOLUME/CTN.:0.014CBM
  • FEATURE:

    ● Dries to a semi smooth,  paintable finish that doesn’t sag or drip.

    ● Suitable to fill small cracks.

    ● Offer protection against moisture and corrosion. 

    ● It can be top-coated with oil-based or latex paint.


    APPROPRIATE CONDITIONS TO SPRAY:

    Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50-90°F(10-32℃) and humidity is below 85% to ensure proper drying. Do not apply to surface, when heated, exceed 200°F(93℃). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.


    SURFACE PREPARATION:

    Remove all dirt and debris from the area to be coated. Wash area with a detergent and water solution, rinse with fresh water, and allow the surface to dry thoroughly. Remove any loose paint or previous coatings with a wire brush or sandpaper. Lightly sand glossy surfaces.Wipe the sanded surface clean when finished.


    APPLICATION:

    Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. A test spray on cardboard is recommended to obtain feel for the spray pattern. Hold can 8-18’’ from the surface and spray in short even strokes. It is recommended to apply a light first coat. Apply a second heavier coat to ensure proper coverage. A thicker film can be achieved by moving the nozzle closer to the surface. Initial spray may have some foaming or bubbling, but will dissipate as the coating dries. For best results, apply 2 coats. Allow to dry 15-30 minutes between coats.


Releted Product
Copyright © 2024 Flamingo Car Care Tech Co.,Ltd. All rights reserved 非商用版本